Awnings & Shutters Sample Kit

About this kit

One kit covering the awning and shutter hardware we source most often. On the awning side: lateral arm shoulder bracket and elbow joint, keder rail with matched PVC cord, a cassette hood extrusion cutoff, and a worm gearbox. On the shutter side: bottom-bar bulb seal, cast end lock, guide rail cutoff, wind-lock clip, and a pintle hinge set. Send us your slat profile, tube size, and finish spec and we match the samples to it.

What's included

• Awning Arm Shoulder Bracket

  Die-cast shoulder bracket with pitch adjustment, paired with an Awning Arm Elbow Joint Assembly

• Aluminum Keder Rail

  Rail cutoff in your groove size with matched PVC Keder Cord for fabric retention checks

• Cassette Hood Extrusion

  Hood profile cutoff for full- or semi-cassette awnings, with Awning Worm Gearbox on request

• EPDM Bottom Bar Bulb Seal — Shutters

  Bulb seal in your T-stem size for rolling shutter bottom bars

• Cast / Stamped End Lock

  Slat end lock and Nylon End Retention Clip (Wind Lock) matched to your slat profile

• Extruded Aluminum Shutter Guide Rail

  Guide rail cutoff with pile weatherstrip in the channel for curtain fit checks

• Bahama Pintle & Strap Hinge Set

  Pintle and strap set (or Colonial Pintle / L-Hinge / Strap Set) in your finish for coastal hardware evaluation

Common use cases

• Lateral arm awning hardware fit and pitch-adjustment checks
• Keder rail and cord retention on awning fabric
• Rolling shutter slat, end lock, and guide rail fit verification
• Hurricane shutter hinge and bottom-bar seal evaluation